Home/Support/Support Forum/XBee Series 3 ND Timeout Issue?

XBee Series 3 ND Timeout Issue?

0 votes
I have my NT value set to 0x0A but the ND acknowledge message -- which usually comes at the end of the ND window -- never arrives. The maximum NT value is 0xFC which means this ack message should show up in about 25 seconds. It doesn't. In XCTU I had to stop the scan manually.

Is there a change in Series 3 ignores the NT value?
asked Oct 7 in XBee3 802.15.4 by JonnyMac New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Set the C8 parameter.
answered Oct 7 by mvut Veteran of the Digi Community (14,777 points)
Thank you. That did the trick.
...