Home/Support/Support Forum/Connectcore MCA GPIO wakeup
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Connectcore MCA GPIO wakeup

0 votes
Hi,

Im trying to use an interrupt on MCA-gpio 1 (configured as active high) to wake up my Connectcore 6UL SBC pro from standby. The interrupt pulls the line low.

I run:

gpiomon --num-events=1 --falling-edge mca-gpio 1 &
standby

The problem is, when standby is run, the MCA gpio pins voltage drops to ~0.8V, triggering its own interrupt and waking it up near instantly. If I run standby without setting the interrupt, the voltage drops too.

Am I missing something to configure the MCA to maintain its voltage regulation etc?
asked Sep 10 in Linux by cstanton New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
Did you modify your device tree to contain something like this to configure MCA_IO0 as wake-up source:

&mca_gpio {
pwroff-wakeup-capable-ios = <1>;
};

then you need to do something like this:
This change in the device tree just enables the wake-up capability of the MCA GPIO. You still need to configure the GPIO as an interrupt on a running system. For example, to configure MCA_IO1 as falling-edge one-shot interrupt, use gpiomon with an ampersand at the end to send the task to the background. Then, power off:

~# gpiomon --num-events 1 --falling-edge mca-gpio 1 &
~# poweroff -f
The '-f' argument is necessary to prevent the poweroff sequence from closing gpiomon.

https://www.digi.com/resources/documentation/digidocs/embedded/dey/3.2/cc6ul/bsp_r_mca-gpio
answered Sep 13 by LeonidM Veteran of the Digi Community (4,359 points)
...