Home/Support/Support Forum/Timeout, Stalled waiting for proper response

Timeout, Stalled waiting for proper response

0 votes
Hi all,

I have used XBee S2C PRO module, while updating the firmware using X-CTU, I have got the Timeout, Stalled waiting for proper response error. Does any body have faced similar kind of problem? How to fix that problem? Any guidance is much appreciable.
asked Jul 19 in IEEE 802.15.4 by Shrestha_hk New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
Sounds like your module is configured for sleep modes. Try setting the radio to defaults and try it again.
answered Jul 21 by mvut Veteran of the Digi Community (14,777 points)
Hi @mvut,

Thank you for the response, the problem occurs with my new PC, but there was no such problem with the same radio with another PC.
You can try reloading the drivers and optimizing them.
0 votes
How is the XBee attached to your computer? Sometimes you need to double check your COM port settings, like Flow Control. They can cause odd problems like that.
answered Jul 23 by plater New to the Community (27 points)
Hi @Plater,

Thank you for your comment.
However, I have double cross-checked the com. port & settings (Baud-9600, Flow Conrol- NONE, Data Bits-8, Parity- NONE, Stop Bits-1). Which are same as of my previous PC. I have suspected the driver of the programmer but while setting the parameters and doing the range test from another XCTU it works fine.
...