Home/Support/Support Forum/xbee 900hp not consuming and transmitting serial data from USB

xbee 900hp not consuming and transmitting serial data from USB

0 votes
I have 2 xbee pro 900hp 200k RF modems setup to act in transparent mode so I can stream data from a GPS from my local xbee to a remote xbee connected to my laptop to log the GPS data. The serial settings are the same for all devices (9600, 8 data, 1 stop, no parity). Both xbees work communicate fine when I connect both to a terminal, but not when I connect the GPS directly to the USB input on the xbee modem. The GPS works fine when I connect to my laptop. My modem model is the XM-M92-UP-UA. Any suggestions on how to have the modem receive data from the GPS when both interfaces are USB?
asked Jul 19 in RF Solutions and XBee by Dhallett New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
I do not expect this to work. For basic USB products you have devices and hosts.

Your laptop is a USB host. The GPS is a USB device. The XBee adaptor is a USB device as well.

You cannot connect a USB device to a USB device, only to a USB host.

You would be best to get a RS232 GPS adaptor and use the XM-M92-2P-UA.


Nicholas Wilson
Your IoT
https://www.YourIoT.com.au
answered 6 days ago by NicholasYourIoT Community Contributor (118 points)
...