Home/Support/Support Forum/Can I remove the wire antenna and solder on an sma connector on an XBee-PRO® 900HP?

Can I remove the wire antenna and solder on an sma connector on an XBee-PRO® 900HP?

+1 vote
I am a grad student in a bit of a tight spot. I have a number of XBee units with wire antennas, however, due to project changes I need to attach external antennas through an sma connector. I know it will void my warranty but is it possible to desolder the wire antenna and add an sma connector to my XBee model?
asked Jul 12 in RF Solutions and XBee by lazyf New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
No it is not recommended to do so as this voids the warranty, and changes the FCC calibration on the module.
answered Jul 13 by mvut Veteran of the Digi Community (14,777 points)
...