Home/Support/Support Forum/Xbee3 reset to default values

Xbee3 reset to default values

0 votes
I have a XBEE3 module in 802.15.4 mode and sometime the module resets to its defaults parameters.
I interface the module to uP using UART in transparent mode.

In firmware I don't enter in command mode, i think is impossible that the module receive the ATRE command.

There is some hardware possibility to reset the module?

Thank's

Daniele
asked Jun 14 in RF Solutions and XBee by danieleGR New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Daniele, No, it does not have a hardware restore function but it does have a reset line that if triggered would power cycle the radio. So if your settings are not written to flash, that would restore it to default settings.
answered Jun 21 by mvut Veteran of the Digi Community (14,777 points)
...