Home/Support/Support Forum/Unable to communicate w a device using IP
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Unable to communicate w a device using IP

0 votes
Have Digi One SP setup to communicate with a serial device on my network. Successfully ping the IP but I'm unable to communicate with my device. Device does not come online thru my appl.
Please advise.

Here are my Digi One SP Configuration Management:

Port Profile: TCP Sockets
TCP Server: Raw TCP Port: 2101 (NOTE: Using 2101 as my port but its showing "Unavailable" in the Digi One SP Configuration Management)
TCP Client: Automatically establish TCP connections is checked; Connect To: Points to my IP; Service: Raw; TCP Port Number: 2101; Flush Start Character: Auto

Device Information:

Model: Digi One SP
Firmware: Version 82000774_V2 01/29/2013
MAC Address: N/A
CPU Utilization: 9%
Up Time: 18 days 16 hours 30 minutes 24 seconds

Network:

DHCP: Port; IP Address: Points to my IP; Host Name: This is blank

Network Diagnostics:

Network Protocols: Route Table

Serial Ports & Diagnostics:

Industrial Protocols; Port 1 (See below)

Profile TCP Sockets: Port Type: RS-232; Baud Rate: 1200 bps; Data Bits: 7; Parity: Even;
Stop Bits: 1; Flow Control: None

Signals DSR, DCD are both green

Services TCP Client: Available; All other services are Unavailable
asked May 19 in Other/Legacy by nicholed New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
If you have not already, I suggest raising a support case with Digi by emailing tech.support@digi.com

Be sure to include the serial number (or the MAC address if there is no serial number).
answered May 28 by jeremym Veteran of the Digi Community (1,687 points)
...