Home/Support/Support Forum/Latency rduction

Latency rduction

0 votes
Hi,
I am seeing a latency around 400ms while transmitting (API mode, command 0x10) data of length 250 bytes(by checking X-CTU console timestamps of TX Packet and RX packet), Please let me know if I can reduce this delay by adjusting any parameters.

Please note that I am using
-115200 baud rate
-Antennas on both side (both nodes are next to each other)
-Speed is set to maximum of 250KBPS

Thanks,
Naga.
asked Apr 13 in IEEE 802.15.4 by sailurao New to the Community (2 points)

Please log in or register to answer this question.

2 Answers

0 votes
Are you sending broadcast or Unicast packets?

Is the device receiving the data a sleeping end node?
answered Apr 13 by mvut Veteran of the Digi Community (14,807 points)
0 votes
Hi,
Destination address is 0000000FFFF (broadcast).
No, the device is not sleeping. I am using XCTU terminal mode, and so DSR is active.
answered Apr 13 by sailurao New to the Community (2 points)
...