Home/Support/Support Forum/Why end devices are removed from network after 2-3 days ?

Why end devices are removed from network after 2-3 days ?

0 votes
I have a xbee3 zigbee module as coordinator and 4 third-party end devices.

I have no problems at the beginning, sending unicast commands with 64-bits addresses, and receiving data (and NC=10).

After 2-3 days, end devices are removed from the network: xbee3 module does not recognize anymore 64-bit adrresses when I try to send unicast commands, and NC goes back to 14.

End devices poll rate is 1 minute but xbee3 module has SP=AF0 and SN=FFFF, which means that it would remove end device only after 2 months.

What could be the problem?
asked Apr 12 in XBee3 ZigBee by HMorais New to the Community (1 point)
edited Apr 13 by HMorais

Please log in or register to answer this question.

1 Answer

+1 vote
 
Best answer
I would suggest starting by checking the SO command. Then check the other devices to see what their sleep settings are at.
answered Apr 13 by mvut Veteran of the Digi Community (14,297 points)
selected Apr 13 by HMorais
Thank you very much !!
...