Home/Support/Support Forum/Is there a way to grab the node_id from a trasmit message without network discovery?

Is there a way to grab the node_id from a trasmit message without network discovery?

0 votes
In my application, I want to check the node identifier belonging to the incoming message (direct/non-broadcast). From the material that I have read, the only way that I see to grab the node identifier is through network discovery. Is there a way to collect this data from an incoming transmission or do I have to build a list from network discovery and cross-reference the address that the message was received from?

Thanks in advance for any help!
asked Mar 31 in XBee3 DigiMesh by blSwagger New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
The node ID is intended to be found off of a Network Discovery. But if you know the 64 bit address of the module and you do not know its NI, then you can send a remote AT command to read that value.
answered Mar 31 by mvut Veteran of the Digi Community (14,297 points)
...