Home/Support/Support Forum/recovering xbee3

recovering xbee3

0 votes
hello, I bought a new Digi xbee3 and this is my first use for it I just put the setting and tried to discover the network of the XBee module(it took a long time without finding any devices for that I stopped it from the stop button). after that, I remove it and plug it again but now the software can not find the module. how it can break by this easy? what I can do to recover it as it was
I didn't do any interrupt process of the xbee to have like this problem with me , what I can do please I need help.
Important note: I can update the firmware but I can't find the xbee3 module when I make a scan
asked Mar 29 in XBee3 ZigBee by Mohamad-Badr New to the Community (5 points)
The problem solved some ways for that.
1- Try pressing the Commissioning button.
2- Try pressing the reset button.
3- Add the device from adding device not discover and try without the check box in the end of the window.
4-Try pressing the Commissioning button four time in rapped succession.
Some times you will need to unplug and re-plug the XBee to your pc

Please log in or register to answer this question.

1 Answer

0 votes
Also make sure that you have XCTU set to the baud rate that you changed the XBee too.
answered Jun 22 by mvut Veteran of the Digi Community (14,574 points)
...