Home/Support/Support Forum/I have Use XBee3 module but in XCTU Software How to change AI Parameter Value ?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

I have Use XBee3 module but in XCTU Software How to change AI Parameter Value ?

0 votes
*** In that AI Parameter I want 0x00 but first I get 0x25 and then 1 hour after 0x22.***
AI (Association Indication)
Reads the Association status code to monitor association progress. The following table provides the
status codes and their meanings.
Status code Meaning
0x00 Connected to the Internet.
0x22 Registering to cellular network.
0x23 Connecting to the Internet.
0x24 The cellular component is missing, corrupt, or otherwise in error. The cellular
component requires a new firmware image.
0x25 Cellular network registration denied.
0x2A Airplane mode.
0x2B USB Direct active.
0x2D Modem shut down. See SD (Shutdown).
0x2F Bypass mode active.
0x30 An upgrade is in process.
0x31 Regulatory testing has been enabled. See Regulatory testing commands and %#
(Enable/disable test mode).
0xFF Initializing.
asked Feb 23 in Digi Connect Cellular by satyaveerSingh New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You don't. The AI reports the status of the module.
answered Feb 23 by mvut Veteran of the Digi Community (14,299 points)
...