Home/Support/Support Forum/in XCTU Tools currently i am working on Xbee 3 module ?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

in XCTU Tools currently i am working on Xbee 3 module ?

0 votes
***********I Know about AI Parameter but How to put 0x00 data in AI parameter but in AI Parameter Display 0x25 and after 1-hour 0x22 data.

AI (Association Indication)
Reads the Association status code to monitor association progress. The following table provides the
status codes and their meanings.
Status code Meaning
0x00 Connected to the Internet.
0x22 Registering to the cellular network.
0x23 Connecting to the Internet.
0x24 The cellular component is missing, corrupt, or otherwise in error. The cellular
component requires a new firmware image.
0x25 Cellular network registration denied.
0x2A Airplane mode.
0x2B USB Direct active.
0x2D Modem shut down. See SD (Shutdown).
0x2F Bypass mode active.
0x30 An upgrade is in process.
0x31 Regulatory testing has been enabled. See Regulatory testing commands and %#
(Enable/disable test mode).
0xFF Initializing.
asked Feb 23 in Digi Connect Cellular by satyaveerSingh New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Your SIM card is either in-active, wrong APN entered in the AN command or you may have the wrong module for the SIM card.
answered Feb 23 by mvut Veteran of the Digi Community (14,818 points)
...