Home/Support/Support Forum/Is there a method to shorten the shutdown time of the XBee Cellular module?

Is there a method to shorten the shutdown time of the XBee Cellular module?

0 votes
We are using the XBee3 LTE-M/NB-IoT device (XB3-C-A2-UT-001) as the communication module for a battery powered microcontroller board. We send messages periodically (most often every 10 minutes) to an MQTT service.

On every transmission, the cellular module wakes up (it takes about 10 seconds to get a valid IP address), sends the data (another approximately 15 secs until the server confirmation is received) and then is set to sleep – either by MicroPython or by asserting the SLEEP_RQ pin high. This is followed by approximately 20 secs (best case) until the ASSOC pin is low (so power can be switched off). The radio module is in PSM and this seems to work correctly.

Question: Is there a method to shorten this 20 sec interval? In Direct USB mode the radio module itself, for example, executes the power off command much faster (AT+ CPWROFF is followed by OK in approximately 3 secs).
asked Jan 25 in XBee Cellular by darius.popa New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
No, there is not. Not to mention the time you are seeing by the CPWROFF commands OK is not accurate as to know when it is safe to power it off. There are other lines that need to be monitored as well. The Digi power off function does this. So it is actually better to leave the radio powered on and to use PSM or the Pin sleep functions.
answered Jan 26 by mvut Veteran of the Digi Community (14,299 points)
Clear, thank you!