Home/Support/Support Forum/XBee Pro SX manual sets to RS-485 (2-wire) by D2 & D3 to 5 and the D7 to 7, how do you change these?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

XBee Pro SX manual sets to RS-485 (2-wire) by D2 & D3 to 5 and the D7 to 7, how do you change these?

0 votes
asked Dec 30, 2020 in Other/Legacy by reg_moen New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
If you use XCTU, it will allow you to change these values. You can also use Remote AT commands via the Digi XBee PRO SX API interface or via AT command mode.
answered Dec 30, 2020 by mvut Veteran of the Digi Community (14,299 points)
...