Home/Support/Support Forum/Is ble.UUID() not supported in the XBee3 Micro with Digimesh?

Is ble.UUID() not supported in the XBee3 Micro with Digimesh?

0 votes
I am trying to pass a hex address to connect to a specific ble service. When I read the documentation from Digi it says that I can make a UUID object by saying ble.UUID(0xBEEF). However even if I include the BLE library from DIGI, it tells me that a reference the uuid() cannot be found in the ble.pyi. Am I doing something incorrectly or is the documentation incorrect?

Thanks!
asked Oct 5, 2020 in RF Solutions and XBee by johnSmit776 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You may be on an older version of the firmware than the manual is written for or you have not imported the proper libraries into your code.
answered Oct 5, 2020 by mvut Veteran of the Digi Community (14,777 points)
...