Home/Support/Support Forum/How can I configure XBee Pro S3B XBP9B ?

How can I configure XBee Pro S3B XBP9B ?

0 votes
https://spin.atomicobject.com/2016/07/18/xbee-tutorial/

I had XBEE Pro S2C and I used to configure them like the link above.

But I didn't understand the functions and settings of Pro S3B.
I am trying to configure them but I can't? Could Someone help me?
My aim is sending GPS value through XBEE Pro S3B with Arduinos.
I did it in PRO S2C with help of the link above.
But I didn't understand the configuration of S3B.
What is the XBP9B-DP , XBP9B-DM , XBP9B-XC. Which function I should use for this.
asked Aug 6, 2020 in RF Solutions and XBee by gunesmadrali New to the Community (2 points)

Please log in or register to answer this question.

2 Answers

0 votes
You should use the XBP9B-DP and API mode.
answered Aug 6, 2020 by mvut Veteran of the Digi Community (14,676 points)
0 votes
"XBP9B-XC" is our legacy XSC firmware. It isn't recommended for new designs anymore. You can therefore rule this one out.

"XBP9B-DM" firmware supports mesh network on our propitiatory 'DigiMesh' protocol. It will provide better throughput on cost of lesser point-to-point transmit range when compare with "XBP9B-DP" firmware.

"XBP9B-DP" don't support mesh & have lower throughput. However, it would be an ideal firmware if you require long distance, low transmission without any hopping node in between.

Mathur
Digi Support
answered Aug 7, 2020 by mathur Veteran of the Digi Community (289 points)
...