Home/Support/Support Forum/XBee Pro S2C - Read NJ timer

XBee Pro S2C - Read NJ timer

0 votes
Hi All
I am using the NJ parameter to allow joining to my network for a pre-determined time. What I want to to however is monitor the XBee module and read back something that tells me if the module is still allowing joins (ie the timer has not run out). I know I could send the NJ command and then start my own timer, but this does not seem to be the best way. Is there a command I can send to tell read if module is still allowing joins?

Many thanks

asked Mar 29, 2018 in DigiMesh Proprietary Mesh Networking by Steve Wiggins New to the Community (1 point)

Please log in or register to answer this question.