Home/Support/Support Forum/Many-to-One protocol setting on X-CTU

Many-to-One protocol setting on X-CTU

0 votes
Hi Friends: I’m working with Xbee S2C modules in API mode and Digimesh firmware version 9000. I want the coordinator to work with Many-to-One protocol, but I cannot find the configuration line in X-CTU software to set Many-to-One protocol. Could you help me with that? Thanks in advance. Eduardo
asked Aug 8, 2017 in DigiMesh Proprietary Mesh Networking by buezase New to the Community (1 point)

Please log in or register to answer this question.

3 Answers

0 votes
Digi Mesh does not support many to one.
answered Aug 8, 2017 by mvut Veteran of the Digi Community (14,362 points)
0 votes
Thank you. Could you please recommend me the protocol that best replace many to one in Digimesh, to set it via X-CTU? Thanks in advance. Eduardo
answered Aug 9, 2017 by buezase New to the Community (1 point)
0 votes
Hello @buezase
I really didn't get your question, but I'll try to answer it though :) . It seems you want to make it be an Point-Multipoint and not a DigiMesh RF, so you'd need to change the TO parameter to 0x40 in spite of 0xC0, which is the default.
answered Sep 1, 2017 by paiusco New to the Community (5 points)
...