Home/Support/Support Forum/Factory Reset of XBee-PRO SX Module

Factory Reset of XBee-PRO SX Module

0 votes
I am working on an embedded system where we'd like to be able to perform a factory reset on our XBee-PRO SX module. We would like to be able to do this if we have lost the ability to communicate over the UART, such as if the BAUD rate has become corrupted.

Is there a way to do this? How?


asked Jul 27, 2017 in RF Solutions and XBee by cread57 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
The ability to restore a module to factory defaults is the same on ALL XBee modules. You hold the DI low and reset the module. This forces you into command mode at 9600 baud. From there, you can issue an ATRE, WR, CN to Restore to defaults, Write to Flash and Exit command mode.
answered Jul 27, 2017 by mvut Veteran of the Digi Community (14,299 points)