Home/Support/Support Forum/Reflash XBee Mesh to Point-to-Point

Reflash XBee Mesh to Point-to-Point

0 votes
Hi,
I have a couple of older XBee radios, XBee Pro DigiMesh 900 P/N XBP09-DMWIT-156.
I wish to use them for point to point communication, rather than in a mesh.
Is it possible to reflash these to achieve point to point?
Thanks.
asked Aug 27, 2016 in IEEE 802.15.4 by picit New to the Community (0 points)

Please log in or register to answer this question.

3 Answers

0 votes
Hi picit,

it possible as point to multi-point try it
answered Aug 29, 2016 by csreddy Seasoned Professional (195 points)
0 votes
Yes, you can reflash the firmware under the "update" menu in XCTU. DM stands for DigiMesh, DP is for P2MP
answered Aug 29, 2016 by DystopianFerret Veteran of the Digi Community (368 points)
0 votes
Again, both below are not fully accurate. The XBP09-DMWIT-156 module is a Digi Mesh product. You can switch the firmware on it from the XBP09-DM (XBee PRO 900 Digi Mesh) to the XBP09-DP (Point to point/multi-point code) modem type.

You can also simply set the DL and DH of the module to match the SL and SH of the receiving module with either firmware thus telling the module to send the data to and only out the UART if the module that has the matching 64 bit address.
answered Aug 29, 2016 by mvut Veteran of the Digi Community (14,777 points)
...