I need to use AT commands over a USB-FTDI explorer to a xBee. I know the name, speed and so on.
Can anyone explain how to do it?
So far, I've used CoolTerm on OSX. I point CoolTerm to the right port, 9600, N, 8, 1.
I've assumed that I should issue the following:
+++ (alone without CR)
ATD1 2 + CR
ATWR + CR and so on
But I never have an OK after the three +s.
Anyone out there using this combination? Which parameters have you set?
FCC ID OUR-XBEE