Home/Support/Support Forum/Use of XBee Sensor with 3rd party gateway

Use of XBee Sensor with 3rd party gateway

0 votes
I am trying to see if I can get an XBee sensor to connect to a 3rd party gateway. I only have the Digi XBee Sensor ZB Bat/L/T and do not have a Digi Gateway.

Is it possible for me to configure the settings on the XBee to talk to the 3rd party gateway w/out any other hardware? If so can you point me in the direction of a post/manual?

Thanks,
Steve
asked Jun 1, 2015 in ZigBee PRO Featureset (and legacy ZNet 2.5) by iacyclone New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
No, you are going to need to have at minimum an XBee module and interface board or an XBee XStick ZB to first allow it to associate. Then you can use over the air commands to adjust the ZS parameter to allow it to talk to 3rd party networks.
answered Jun 2, 2015 by mvut Veteran of the Digi Community (14,297 points)
...