Home/Support/Support Forum/Reset Current

Reset Current

0 votes
I'm using the XBee-Pro-868.
I reset by switching my output from from open drain to
output "0" on Pin 5. The current goes to about 140 mA.
After releasing pin 5, the current is normal. I get the Modem-Status message HW-Reset.
Why is the current so high?
asked Mar 20, 2015 in XBee Programmable Development by Bummibaer New to the Community (5 points)

Please log in or register to answer this question.

1 Answer

0 votes
Most likely because you are holding the module in a reset state.
answered Sep 15, 2015 by mvut Veteran of the Digi Community (14,807 points)
...