Home/Support/Support Forum/Info on intefacing Matlab gui with a generator using Xbee

Info on intefacing Matlab gui with a generator using Xbee

0 votes
I'm going to monitor the status & control ( turn on/off) a generator using a Matlab based GUI from a PC over xbee communication. I was wondering if this procedure is accurate PC>xbee (USB dongle) > xbee >arduino > generator

Or is it this approach , using a 2nd arduino +xbee instead of the usb dongle for sending & receiving data to the 1st arduino that is connected to the generator

PC>Arduino >xbee >xbee>arduino > generator
asked Jan 6, 2015 in RF Solutions and XBee by kreiss12 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Of the two, the first is the best. But why not do PC > XBee USB > XBee DIO adapter?
answered Jan 6, 2015 by mvut Veteran of the Digi Community (14,874 points)
...