Home/Support/Support Forum/How to remotely reset network config. on ZigBee routers

How to remotely reset network config. on ZigBee routers

0 votes
Hello,
I have some XBee devices configured as routers, connected to a coordinator (Gateway X4), but I had to replace the coordinator and I don´t have info on the PAN ID that was being used, and I can´t fisically reach the routers to reset them. Is it possible to remotely reset them using an XStick USB as coordinator and modify their PAN ID so they can connect to the XStick or a new gateway ?
Regards,
asked Oct 7, 2014 in IEEE 802.15.4 by thiagorod New to the Community (1 point)

Please log in or register to answer this question.

2 Answers

0 votes
See Chapter 3 of the XBee Pro User Manual under Coordinator Operation - Replacing a Coordinator. Details are in the documentation.
answered Oct 7, 2014 by trooper2 Veteran of the Digi Community (589 points)
0 votes
Yes, I understand that, but I can´t read the parameters from any router (I can´t get to them, unless I can do this remotely). This is why I would like to remotely reset them using the XStick... but I would still need the PAN ID to connect to them.
answered Oct 7, 2014 by thiagorod New to the Community (1 point)
...