Home/Support/Support Forum/Why am I receiving a Modem Status (0x8A) on broadcast messages (XBee)?

Why am I receiving a Modem Status (0x8A) on broadcast messages (XBee)?

0 votes
I am sending a Remote AT Command Request in broadcast (without ACK - frameID = 0x00), from my Coordinator API, to set the CB command to 1: this simulate 1 commissioning button press in software of the remote device in order to receive a Node Identification Indicator.

When I send the first packet:

7e 0 10 17 0 0 0 0 0 0 0 ff ff ff fe 1 43(C) 42(B) 1 66

I receive the following Node Identification Indicator frame:

7e 0 27 95 0 13 a2 0 40 aa d0 6 f9 5d 2 f9 5d 0 13 a2 0 40 aa d0 6 52 4f 54 45 41 44 4f 52 0 ff fe 1 1 c1 5 10 1e 7f

but, if I send the same Remote AT Command again (CB command with parameter 1), I get this two Modem Status frames:

7e 0 2 8a 1 74
7e 0 2 8a 6 6f

The first one means a Watchdog timer reset (1), and the other means a Coordinator started(6). I checked the voltage over my XBee and it's everything ok (3,3V), so is it not supposed to reset?. If I send the Remote AT Command again (a third time), I will get the Node Identification Indicator frame. And sending a second time (fourth time), I get the two Modem Status frames. Then, it's keep repeating..

Why this happen? I had to send twice in order to get the response I wanted.
asked Jul 17, 2014 in ZigBee PRO Featureset (and legacy ZNet 2.5) by renatogbp New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
How much time had passed between when the first one was issued and the 2nd one was issued?
answered Jul 18, 2014 by mvut Veteran of the Digi Community (14,676 points)
It's when I press a button. At first press, I get right, on second press it gets wrong, I think is less than 5 seconds
What firmware version and what product are you working with?
Modem: XBee XB24-ZB, Function Set: ZIGBEE COORDINATOR API, Version: 21A7
Modem: XBee XB24-ZB, Function Set: ZIGBEE ROUTER AT, Version: 22A7.

When I sent the remote AT command request, I was enabling entries e router repair (Option 0x00). I tested disabling it (Option 0x01) and I didn't get the modem status anymore, why?
I would have to see the entire frames you are sending in order to determine that.
The frame I am sending I wrote on my question:
7e 0 10 17 0 0 0 0 0 0 0 ff ff ff fe 1 43 42 1 66
this is the only frame I sent, one time I get the right answer and other time I get the modem status, it keeps repeating.
Sounds like you were using Application level retries that were causing issues.
...