Home/Support/Support Forum/[AnyWhereUSB] Monitoring power supply?
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

[AnyWhereUSB] Monitoring power supply?

0 votes
Hello,

It's possible to monitoring the two power supply in AnyWhereSUB product via SNMP or other?

Thank's in advance
asked Jun 2, 2014 in USB by hjbe New to the Community (0 points)

Please log in or register to answer this question.

2 Answers

0 votes
The only traps that are available are discussed in the AnywhereUSB Installation Guide

which Anywhere USB are you referring to. If it is AUSB/14 then the two power supply is for the failover connection.
answered Jul 14, 2014 by sans0909 Veteran of the Digi Community (280 points)
Hi,

I do not understand your answer.

It's possible to monitoring the two power supply via SNMP protocol?
0 votes
Unfortunately, SNMP functionality is limited for the AnywhereUSB G2 models.

1. The only traps that are available are discussed in the AnywhereUSB Installation Guide

2. The Alarm functions are applicable to the DB9 serial port, if you're using the RealPort driver to connect that serial port to a computer over the network.

3.Digi do not offer any MIBS for AUSB at this time.
answered Jul 15, 2014 by sans0909 Veteran of the Digi Community (280 points)
Ok, it's not possible.

Thanks for your response
...