Home/Support/Support Forum/Why is my XBee receiving so many bogus digital I/O signal edges ?

Why is my XBee receiving so many bogus digital I/O signal edges ?

0 votes
I have a remote switch operating as a "sensor" over a pair of XBee Pro:s. The remote end has a pull-down resistor, so the input is not "floating" midway. Otherwise it works as expected, but I receive a lot of transient spikes going up and back down in fractions of a second. What could be the cause and fix of this ?
asked Mar 3, 2014 in RF Solutions and XBee by luotzi New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
You are most likely using samples before transmit instead of change detect. For this type of application, change detect would be better of being used.
answered May 7, 2014 by mvut Veteran of the Digi Community (14,352 points)
...