I have an XBP24 802.15.4 with an 10ED firmware plugged on an rs232 Xbee PKG.
The configuration is all defaults except :
- DL : 0xFFFF
- BD : 7 (115200)
I send a stream of data to the module that is above the available bandwidth. So i don't expect to receive any good data on other modules.
But the problem is that, at some point, the transmitter stall. If i send one byte per one byte (by hand in a terminal for instance) the green led show that the module receive the data, but the data is not sent.
The receiver is still working.
My problem is that the transmitter can be frozen. I would like to come back to a nominal behaviour if i throttle the data throughput.
The only way to be able to send data again is to unplug / plug the rs232 cable (with power still working).
Is there anybody that have encountered the same problem ?
How can i solve it ?