Home/Support/Support Forum/Digi serial port in non-global Solaris zone
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Digi serial port in non-global Solaris zone

0 votes
Hi!

Is it possible to use a Digi serial device in a non-global Solaris zone ?

It works fine in the global zone as expected, but if I try to access it in a non global zone, I get no output in the terminal program. I can see active link lights and the byte counters increase in the Portserver webpage.

This is the steps I have taken:

1. Installed the Digi driver in the global zone
2. Created non-global zone an added this to the zone config:
zonecfg:zone> add device
zonecfg:zone:device> set match=/dev/dpr/01001s
zonecfg:zone:device> end
3. Manually created the device in the non-global zone from the global zone:
mkdir /zones/sol10z/dev/dpr
cd /zones/sol10z/dev/dpr
mknod 01001s c 310 3264
4. Tested with Minicom and Tip with the same settings as in the global zone.

It looks like data is going through, but I canĀ“t get any output in the terminal program.

Anyone got this working ?
asked May 23, 2013 in Realport by ddelin New to the Community (0 points)

Please log in or register to answer this question.

...