Home/Support/Support Forum/Configure XBEE PRO S2 module as ZIGBEE COORDINATOR API Using XCU

Configure XBEE PRO S2 module as ZIGBEE COORDINATOR API Using XCU

0 votes
Hi. I now have the same problem.
Could you guide me to get the xbee pro s2 communicating ? I have them both in API mode. One is a coordinator and the other a router. I'm sending data through the router xbee to the coordinator but the coordinator is not receiving. Any help is highly appreciated.
asked May 3, 2013 in ZNet 2.5 by emma New to the Community (0 points)
edited May 3, 2013 by emma

Please log in or register to answer this question.

1 Answer

0 votes
Hi Emma, What your router device configuration OP or OI or CH command are appearing in X-CTU?
answered May 3, 2013 by chobichan Community Contributor (100 points)
Actually, i just managed. Thanks a lot though.
...