Home/Support/Support Forum/I am using two Xbees to transmit just the Data I/O, what do I connect USART pins to?

I am using two Xbees to transmit just the Data I/O, what do I connect USART pins to?

0 votes
I'm not using the interface board, just a breadboard with exporer for conencting to pc via usb.
asked Apr 25, 2013 in ZNet 2.5 by sd New to the Community (0 points)
recategorized Apr 25, 2013 by charliek

Please log in or register to answer this question.

1 Answer

+1 vote
Hello charliek,

Could you be more explicit on which module are you using (programmable, non-programmable...?). I am not sure that I understand the question, if you are not reading nor writing to/from the UART it's not necessary to connect it to anything. Best regards,
answered Apr 25, 2013 by spastor Veteran of the Digi Community (403 points)
...