Home/Support/Support Forum/Factory reset on ME 2910
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Factory reset on ME 2910

0 votes
Hello,

I need to have the possibility to do a "factory reset" on
my ME9210 (w. Linux).
I know that there`s a switch on the development board wich can do a hard reset. I want to use this switch (resp. the connected pin on the me9210) to do a factory reset with setting network to (my) default settings and reset the admin password for my website running on the 2910.

Is there any way to check after a reset, if the ME9210 has been resetted by switch / pin or if it just got powered down by a user?

Or is there any better way to do a factory reset ?

Many thanks in advance,

regards,

Micha
asked Nov 19, 2012 in Linux by decision New to the Community (2 points)
recategorized Dec 4, 2013 by tuxembb

Please log in or register to answer this question.

3 Answers

0 votes
Is this a Plug and Play device or Linux/NETOS device?
answered Nov 22, 2012 by tuxembb Veteran of the Digi Community (288 points)
0 votes
Hello,

its a Linux device.

Regards,

Micha
answered Nov 23, 2012 by decision New to the Community (2 points)
0 votes
I found out that UBOOT recognizes that the reset switch was used. On the UBOOT boot screen there's displayed "RESET: SRESET".

Is there any possibility to get that info when linux is booted?

Regards,

Micha
answered Dec 4, 2012 by decision New to the Community (2 points)
...