Home/Support/Support Forum/Difference between 4 "Function Set" options for S3B XSC firmware?

Difference between 4 "Function Set" options for S3B XSC firmware?

0 votes
I am working on a product using the DIGI Xbee S3B RF module. I need to get a replacement for a legacy system from ~2014/5.

The software running on the microcontroller uses AT commands which identifies it as running the XSC firmware. However, there are 4 different options under the XSC function set. I can't find any documentation on what the difference is.

Does anybody know where I can find the difference between the 19200, 19200 920MHz, 9600, and 9600 920MHz "Function Set" options? I need to find the difference to figure out which one will be compatible with the old system.

asked 5 days ago in RF Solutions and XBee by L0uisc New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

+1 vote
Best answer
The 19,200 and 9,600 refer to both the default baud rate and the over the air data rates the radio communicates at.

The 920 MHz function set options are for use in Australia only.
answered 4 days ago by mvut Veteran of the Digi Community (14,874 points)
selected 4 days ago by L0uisc