Home/Support/Support Forum/Want not to operate an orphan scan of zigbee end device

Want not to operate an orphan scan of zigbee end device

0 votes
Hello,

I have some questions

I'm using one coordinator and 8 end-devices (Zigbee) for monitoring system.

When leaving work, I have to turn off the power of coordinator (it must be done because of safety).
Then, end-devices which use battery keep awake and scan their parent, so batteries are gone too fast.

1) Is there any method to prevent Zigbee end-device which is loosing parent from waking up?
2) Could I solve that problem in 802.15.4 Firmware?

If there is someone who can solve this problem, please let me know. Thanks.

AT Parameter (sleep) such as :
- SP : C8 (2 sec)
- SN : D2F0
- SM : [4] Cyclic sleep
- ST : 4E20 (20 sec)
asked Apr 6 in RF Solutions and XBee by Jeon Youngmin New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
For your network, it would be far better to switch to the 802.15.4 code on all of the modules.
answered Apr 8 by mvut Veteran of the Digi Community (14,294 points)
...