Part Number: WR21-M72B-DE1-SB
Ethernet 0 MAC Address: 00:04:2d:0e:2c:96
Firmware Version: 22.214.171.124 (Apr 13 2020 11:28:09)
SBIOS Version: 7.67u
Build Version: WW
HW Version: 1207a
The system is port isolate mode, Eth1 is the local interface 192.168.51.41/29 and it the gateway for all devices at the site.
Eth0 is in DHCP mode and gets its address from the telco supplied fiber router.
Its up on fiber and working fine, great.
I have three default routes setup:
1. Route0 is Eth0, metric 1, if this route comes up, deactivate PPP1 and PPP3,
2. Route1 is PPP1, metric 1,
3. Route2 is PPP3, metric 10.
Problem is, look at the routing table:
Destination Gateway Metric Protocol Idx Interface Status
0.0.0.0/0 192.168.1.1 2 Static 0 ETH 0 UP
0.0.0.0/0 100.66.61.221 2 Static 1 PPP 1 UP
0.0.0.0/0 0.0.0.0 - Static 2 PPP 3 OOS
Why hasn't PPP1 gone OOS? Its set to go OOS 1 second after default route0 comes into service.
What am I doing wrong here?