Home/Support/Support Forum/Where is RX and TX located on the XBee?

Where is RX and TX located on the XBee?

0 votes
where is the RX and TX on the xbee? Do I need to buy the separate board in enable to use RX and TX or can I just use RX and TX from my Arduino and hook it up to for example D4 and D5 on the xbee?
asked Oct 27, 2020 in RF Solutions and XBee by davidgar026 New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
That would be Data In and Data out on the XBee (Most use Pins 2 and 3 for that).

There are 3rd party adapter boards you can use that will connect an XBee to an Aurdino
answered Oct 27, 2020 by mvut Veteran of the Digi Community (14,807 points)