Home/Support/Support Forum/Return ConnectCore6UL to factory state
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

Return ConnectCore6UL to factory state

0 votes
I am developing factory-programming for products containing ConnectCore6UL 256-256-W-BT modules. The devices I have contain custom (product) firmware.

I would like to return the devices to the "factory" state, as shipped from Digi.
I do not have JTAG available - only SD and UART.
I'm hoping that perhaps there's a pre-built SD card image that I can download and use to reset the internal flash to stock state - which I assume wuuld be that just u-Boot is loaded on to the module?
asked Oct 21, 2020 in Linux by IanJ New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

–1 vote
You should be able to do it by following the instructions on programming the firmware.
answered Oct 21, 2020 by Campbell Veteran of the Digi Community (780 points)
No, this is almost the opposite of what I want to acheive -- I want to get back to the no-Linux and orginal U-Boot-only statue.