Home/Support/Support Forum/AT command V+ doesnt work

AT command V+ doesnt work

0 votes
hello,

i'm trying to use AT V+ on a xbee3 digimesh 2.4 module to get/set the voltage supply threshold but always get an ERROR.

Firmware is 300B, xbee3 model XB3-24

Any ideas?
asked Oct 7 in XBee3 DigiMesh by aschroeder New to the Community (1 point)

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
That is because the command is invalid. That is to say, per the manual, there is No V+ command for this product.

https://www.digi.com/resources/documentation/Digidocs/90002277/#Containers/cont_at_cmd_firmware.htm%3FTocPath%3DAT%2520commands%7CDiagnostic%2520commands%2520%25E2%2580%2593%2520firmware%252Fhardware%2520Information%7C_____0
answered Oct 7 by mvut Veteran of the Digi Community (13,489 points)
selected Oct 8 by aschroeder
Ah, sorry, my mistake
...