Home/Support/Support Forum/Can you interface with a Sengled door sensor using the XBee3 as a coordinator?

Can you interface with a Sengled door sensor using the XBee3 as a coordinator?

0 votes
I was able to find the sengled door sensor in XCTU, but every time I click on it it says could not initialize device and I've tried changing the profile as stated on digi webpage using HA profile but it is unsuccessful. Is a door sensor that uses zigbee like the sengled door sensor something that can be interfaced with the xbee3? The goal is to send whether a door is open to an arduino.
asked Aug 13 in XBee3 ZigBee by Pkwom New to the Community (2 points)

Please log in or register to answer this question.

1 Answer

0 votes
 
Best answer
The XCTU software is only designed to allow you to modify/upload firmware to Digi XBee products. XCTU will allow you to see that the device has associated but it is not going to be able to read its firmware or make changes to that firmware as it is NOT a Digi product.
answered Aug 13 by mvut Veteran of the Digi Community (13,472 points)
selected Aug 13 by Pkwom
...