Home/Support/Support Forum/How can I configure XBee Pro S3B XBP9B ?

How can I configure XBee Pro S3B XBP9B ?

0 votes
https://spin.atomicobject.com/2016/07/18/xbee-tutorial/

I had XBEE Pro S2C and I used to configure them like the link above.

But I didn't understand the functions and settings of Pro S3B.
I am trying to configure them but I can't? Could Someone help me?
My aim is sending GPS value through XBEE Pro S3B with Arduinos.
I did it in PRO S2C with help of the link above.
But I didn't understand the configuration of S3B.
What is the XBP9B-DP , XBP9B-DM , XBP9B-XC. Which function I should use for this.
asked Aug 6 in RF Solutions and XBee by gunesmadrali New to the Community (2 points)

Please log in or register to answer this question.

2 Answers

0 votes
You should use the XBP9B-DP and API mode.
answered Aug 6 by mvut Veteran of the Digi Community (13,094 points)
0 votes
"XBP9B-XC" is our legacy XSC firmware. It isn't recommended for new designs anymore. You can therefore rule this one out.

"XBP9B-DM" firmware supports mesh network on our propitiatory 'DigiMesh' protocol. It will provide better throughput on cost of lesser point-to-point transmit range when compare with "XBP9B-DP" firmware.

"XBP9B-DP" don't support mesh & have lower throughput. However, it would be an ideal firmware if you require long distance, low transmission without any hopping node in between.

Mathur
Digi Support
answered Aug 7 by mathur Community Contributor (98 points)
...