Home/Support/Support Forum/XBee 3 LTE-M cell firmware update fails

XBee 3 LTE-M cell firmware update fails

0 votes
Hi,

I have the XB3-C-A2-UT-001 cell module, and I can't get the cell firmware update to complete in X-CTU. I am using the XBIB-CU-TH dev board and set to cell bypass mode, and it always gets stuck in the state "Waiting for modem port..." for a very long time (about 5 minutes per try), and after retrying 3 times it quits with error "Could not communicate with the cellular modem over USB". I tried reinstalling the cellular drivers from ublox and that did not help. I even tried another Xbee module and still had the same issue. I am wondering what else to try to get it to work.
asked Aug 6 in XBee3 Cellular by tpeterson New to the Community (3 points)

Please log in or register to answer this question.

3 Answers

0 votes
 
Best answer
It turns out that the 2nd USB cable was somehow bad- I tried with a different cable and it worked.
answered Aug 12 by tpeterson New to the Community (3 points)
selected Aug 12 by tpeterson
+1 vote
Are you connecting the Micro USB cable to the board and PC as well or just the main USB cable?
answered Aug 6 by mvut Veteran of the Digi Community (13,094 points)
I have both cables plugged in
Check the two switches by the Micro USB port and make sure they are set to facing the edge of the board.
Yes they have always been set to the edge of the board and it still does not work
What I would suggest is contacting Digi Support at tech.support@digi.com
+1 vote
Try these steps:
- Slide switches left towards board end or I2C bus is disconnected in custom hardware.

- Ensure both USB's are connected to computer and device manager recognizes the XBee FTDI chip.

- Ensure the USB C is connected to a USB 3.0 port on your computer for XBIB-CU-TH or the XBee is sufficiently powered in custom hardware. Powering specs in manual.

- Configure the modem in XCTU:
~ First write default settings.
~ Write 'Bypass Mode' to AP
~ Write 'USB Direct' to P1 (Configs GPIO for modem USB)
~ Write '4' to DO (Enables USB modem VBUS)

- Press the reset button.

- Ensure your computer now recognizes the Qualcomm modem in device manager.

Proceed as usual.
answered Aug 11 by soterboat New to the Community (13 points)
...