Home/Support/Support Forum/XBee 900HP programmable - pull down & drive strength settings

XBee 900HP programmable - pull down & drive strength settings

0 votes
I am using the 900HP(programmable). How do I configure an input as a pull-down resistor in CodeWarrior/SDK? I seem to only be getting the choice of pull-up when I select my pin as an input under GPIO Type in the Smart Editor. I have PNP devices that source voltage to the input. I know this is less common than a pull-up, but just curious.

I don't see anything in the documentation about this Pull-Down input capability, or what is meant by Drive Strength.

Thanks
asked Jul 15 in DigiMesh Proprietary Mesh Networking by D2K New to the Community (11 points)

Please log in or register to answer this question.

1 Answer

0 votes
Just checking in on this one. I'm still not entirely sure what the approach is going to be here unless I can just override the value in code, which I have not yet tried to see what happens in the XML after doing so.
answered Jul 22 by D2K New to the Community (11 points)
...