Could anyone please refer me to documentation on how to wire up and use the PE Micro Multilink debugger with the XBee Pro S3B 900HP? I need to know the pinout since I’m using a Grove board and will likely need to just individually pin the connections. I am also having trouble finding any documentation that looks official on this matter. Some of the stuff I find goes down these wormholes of flashing new bootloaders onto the XBee, as well as the XBee’s power output going from 18dBm to 12dBm if programmed using a Multilink.
Is there something official I can reference here?
edit: There are 4 of 6 pins recommended for use on Port C / BDM of the Multilink. I currently have the Grove/Xbee hooked up via USB-C to one port of my laptop and the Multilink to another USB port. The 6-pin connector is individually pinned out since there is no 6-pin connector on the Grove. TVCC borrows VCC from one of the Grove connections, same for GND, then the BGND(1) on the Multilink is connected to pin 8 of the XBee. The RESET pin on the Multilink (4) is connected to RESET (5) of the XBee. Currently I am getting the following error in CodeWarrior when trying to Run As >> CodeWarrior Download in the project explorer for the Bootloader project:
Error. Check Port, Power and Connections. Firmware update Failed. Retry?
Not sure what the issue is here.