Home/Support/Support Forum/Why is XBEE3 continuously resetting after programming?

Why is XBEE3 continuously resetting after programming?

0 votes
We have developed a custom battery powered board that we are programming with the XBEE SMT Grove Development Board. After programming the XBEE3 resets about every 10-15 seconds. When connected to the XBEE SMT Grove Development Board it doesn't reset but stand alone it does. Are there pull up resistors that are required on any of the programming lines for normal operation?
asked Jun 10 in XBee3 DigiMesh by MSGC New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
MSGC,

I would suggest looking at the hardware reference manual at https://www.digi.com/support/productdetail?pid=5637&type=documentation and the interface board schematics at https://www.digi.com/support/knowledge-base/interface-board-schematic
answered Jun 10 by mvut Veteran of the Digi Community (12,789 points)
...