Home/Support/Support Forum/DigiOne IA resets after passing a command from Modbus RTU to Modbus/TCP and back.
Welcome to Digi Forum, where you can ask questions and receive answers from other members of the community.

DigiOne IA resets after passing a command from Modbus RTU to Modbus/TCP and back.

0 votes
Setting up a digiOne IA to pass Modbus RTU Master to Modbus/TCP slave.
The messaging works and we get data back but after the first message the DigiOne IA resets and take about 20-30 seconds to come back up.
Has anyone seen this behavior before and have any ideas on how to prevent it?
asked May 20 in Modbus and Industrial Automation by AAtencio New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Hello, and welcome to Digi forum,
What you are describing will require troubleshooting. Please open a support case with Digi Tech support by sending email to tech.support@digi.com

Michael
Digi Tech Support
answered May 28 by shatman Community Contributor (109 points)
...