Hello, I am trying to make the XBee device work with an Arduino and the SparkFun XBee Explorer Regulated module. I have the XBee 3 PCB Antenna on the SparkFun module and connected the 4 pins to the Arduino like so:
5V - 5V
GND - GND
RX - TX
TX - RX
I installed the XCTU software and tried discovering the device but with no luck, I tried adjusting the discovery settings. I checked all checkboxes except the ones under Parity (only None was selected). It didn't recognize the device. I tried switching up the RX to RX and TX to TX but, it didn't recognize it neither.