Home/Support/Support Forum/API output modes

API output modes

0 votes
The XCTU (and direct AT commands) allow for the AO command to have only the following values for its parameter: 0,1,3,7,B . I would like to set bit 4 (Echo supportet ZDO requests to the serial port) - but I get an error for any value of 10 or greater. Need clarification.
asked May 19 in XBee3 ZigBee by Feuerstein New to the Community (2 points)

Please log in or register to answer this question.

2 Answers

0 votes
What firmware version are you working with? An AO of 0x10 would enable bit 4 which should do what you want.
answered May 19 by mvut Veteran of the Digi Community (12,756 points)
0 votes
The device is XB24C with Firmware Ver. 4061.
Set as a Coordinator (CE=1 ; ZS=2 ; EE=1 ; EO=2).

As reported, the problem is that the ATAO10 AT command return ERROR (actually only the mentioned
parameters 0,1,3,7,B return OK.

What may be the reason for this behavior ?
answered May 20 by Feuerstein New to the Community (2 points)

The S2C does not support that feature. That is why you can't enable that function.