Home/Support/Support Forum/XBee3 LTE Cat 1 (Verizon) - Can't connect, not activated?

XBee3 LTE Cat 1 (Verizon) - Can't connect, not activated?

0 votes
I recently picked up the Verizon XBee3 LTE Cat 1 Development Kit (XK3-C-V1-T-UB) from Digikey and followed the setup instructions, but I haven't been able to establish connection with any endpoints despite being connected to the cellular network.

I issued an HTTP GET request to httpbin.org per the documentation (https://www.digi.com/resources/documentation/digidocs/90002350/default.htm#Tasks/t_get_http.htm%3FTocPath%3DXBee%2520connection%2520examples%7C_____5) and while I see a response, it's a 302 response pointing to "http://quickaccess.verizonwireless.com/bbportal/oem/start.do?encryptedinfo=[.....]".

My understanding is that this is Verizon's activation portal, but I was under the impression that the SIM inside the dev kit was pre-activated. I don't see any obvious way to activate it, and the call to Digi's activation support went to voicemail. Is there something I'm missing?

ATPH = blank
ATAI = 0
I have a valid module IP address
asked May 8 in XBee Cellular by fierst New to the Community (0 points)

Please log in or register to answer this question.

1 Answer

0 votes
Fierst,

That is an active SIM card and connection. Try the echo example and see what happens.

Digi Support
answered May 11 by mvut Veteran of the Digi Community (13,100 points)
I don't receive any response from the echo server. Sending the EOL character (0x0D) doesn't trigger any response, nor does sending a string of characters followed by 0x0D. I tested the settings in Putty by opening a raw connection to the echo server from my PC and received a response, so something with the connection between my XBee and the server is off.
Fierst,

Try doing a restore to defaults and then try following the directions again for the Echo server. You should not be sending an 0x0D but just a <CR>

Digi Support
OK, settings restored to default, I followed the instructions:

Destination IP = 52.43.121.77
Destination Port = 2329
Text Delimiter = D (for Carriage Return)
IP = TCP [1]

Opened the port and pressed enter, no response.
Typed some characters and pressed enter, no response.

The result in the console window looks like the following: https://imgur.com/a/Gx2RVgZ

(If the image doesn't load, I get no response from the server)

I still have good association (0), an IP, Cell Network strength, etc.
I am getting
f
Echo Server Starts
f


So I am sure the server is working. Are you putting in a 0D for the TD or just D?
Just D, and the hex output shows a carriage return.
That should be a 0D and not just D.
I set it to 0D and saw no difference. I still get no response from the echo server, Eliza, time server, etc. and HTTP Get requests still redirect me to that Verizon site.
I would recommend sending an email to tech.support@digi.com
...